Testing and modelling of a novel oil-free co-rotating scroll machine with water injection

Efficient compressed air energy storage requires reversible isothermal compression and expansion devices. The isothermal compression and expansion processes can either be approached by several stages with intercooling or by the more convenient injection of a liquid, often water. While volumetric machines are readily available for dry processes the compression and expansion of a gas with the presence of liquid is still problematic. The concept of a co-rotating scroll has been identified as a promising technology to cope with the presence of liquid. The current paper discusses the first experimental results of an oil-free co-rotating scroll prototype tested in expansion mode on a wide range of rotational speeds, varying water injection flow rates and with different nominal flank clearances. A maximal overall isothermal efficiency of 34% and a maximum output power of 1.74kWel were measured with this first prototype, providing the proof of the technical feasibility of the oil-free co-rotating scroll expander concept. The experimental data indicate a positive effect of water injection suggesting good heat transfer behaviour between the water and the air in the individual chambers, which is a result of the relatively long residence time compared to other volumetric concepts. The experimental sensitivity analysis yields a strong dependency of the machine performance on both the nominal flank clearance and on the injected water rate. The analysis through a semi-empirical model suggests the inversion of a classical trend, i.e. the increase in total leakage area with rotor speed. This is resulting from the centrifugal loads acting on the flanks and deforming them to produce increased radial and flank clearances. The injection of water is suggested to significantly decrease the leakage. A deterministic reduced order model of the co-rotating scroll expander was developed in order to better understand the governing phenomena within the machine and to provide design guidelines for further prototypes. A novel leakage model takes into account for the structural deformation of the flanks and the scroll involutes as a result from the rotor speed. By means of this comprehensive thermodynamic model, mechanical power, mass flow rate and exhaust temperature were predicted within a range of ±12% and ±4K respectively compared to experimental data. The calibrated model suggests an achievable isothermal efficiency of 87% for an improved co-rotating scroll concept, thus offering promising perspectives not only for compressed air storage, but also for wet expansion in Absorption Power Cycles, trilateral flash cycle and Organic Rankine Cycles.