IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v14y2022i16p10068-d888075.html
   My bibliography  Save this article

Study on Overburden Movement Deformation and Roof Breakage Law of Under-Protective Steeply Inclined Coal Seam Mining

Author

Listed:
  • Xinshan Peng

    (School of Safety Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China)

  • Lingling Qi

    (School of Safety Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China
    MOE Engineering Research Center of Coal Mine Disaster Prevention and Emergency Rescue, Jiaozuo 454000, China
    Collaborative Innovation Center of Coal Work Safety and Clean High Efficiency Utilization, Jiaozuo 454000, China
    State Key Laboratory Cultivation Base for Gas Geology and Gas Control, Jiaozuo 454000, China)

  • Zhaofeng Wang

    (School of Safety Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China
    MOE Engineering Research Center of Coal Mine Disaster Prevention and Emergency Rescue, Jiaozuo 454000, China
    Collaborative Innovation Center of Coal Work Safety and Clean High Efficiency Utilization, Jiaozuo 454000, China
    State Key Laboratory Cultivation Base for Gas Geology and Gas Control, Jiaozuo 454000, China)

  • Xiaoqing Zhou

    (School of Safety Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China)

  • Chunlei Hua

    (School of Safety Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China)

Abstract

The occurrence of a steeply inclined coal seam is extraordinary, and the coal body is seriously damaged by extrusion. The most steeply inclined coal seam is a high-gas or -outburst coal seam, and protective layer mining is the safest and most effective measure for regional prevention of coal and gas outburst. Based on considering the coefficient of lateral pressure and vertical height of the section, the deflection of the basic roof of the steeply inclined protective layer in a mine in western Henan, China, was calculated using the deflection calculation method of the thin-plate theory of elasticity. Using MATLAB to understand the deflection, the deflection curve was obtained. The law of rock movement and deformation in the mining process of the protective layer was studied by a similarity simulation experiment. The results show that, after mining, the roof mainly sinks slowly without large-scale collapse, and the largest rock strata movement is located in the upper part of the slope. Rock strata movement and fracture development can relieve the pressure of the protected layer and provide a channel for gas migration and drainage. The mining conditions of the protected layer will not be destroyed, and mining this type of protected layer in this mine has better safety and feasibility. The conclusions of this study have a guiding and scientific significance for the control of surrounding rock and the layout of gas drainage boreholes of under-protective steeply inclined coal seam mining.

Suggested Citation

  • Xinshan Peng & Lingling Qi & Zhaofeng Wang & Xiaoqing Zhou & Chunlei Hua, 2022. "Study on Overburden Movement Deformation and Roof Breakage Law of Under-Protective Steeply Inclined Coal Seam Mining," Sustainability, MDPI, vol. 14(16), pages 1-13, August.
    • Handle: RePEc:gam:jsusta:v:14:y:2022:i:16:p:10068-:d:888075
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/14/16/10068/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/14/16/10068/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Haifeng Wang & Yuanping Cheng & Liang Yuan, 2013. "Gas outburst disasters and the mining technology of key protective seam in coal seam group in the Huainan coalfield," Natural Hazards: Journal of the International Society for the Prevention and Mitigation of Natural Hazards, Springer;International Society for the Prevention and Mitigation of Natural Hazards, vol. 67(2), pages 763-782, June.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Sheng-Jie Fang & Bing Liang & Wei-Ji Sun & Zhan-Shan Shi & Jian-Feng Hao & Bei-Fang Wang & Xiao-Yong Zhang, 2022. "Study on Stress Evolution Law of Overburden under Repeated Mining in Long-Distance Double Upper Protective Layer," Energies, MDPI, vol. 15(12), pages 1-24, June.
    2. Zuxun Zhang & Hongtu Wang & Bozhi Deng & Minghui Li & Dongming Zhang, 2018. "Field Investigation of Hydraulic Fracturing in Coal Seams and Its Enhancement for Methane Extraction in the Southeast Sichuan Basin, China," Energies, MDPI, vol. 11(12), pages 1-15, December.
    3. Rui Gao & Bin Yu & Hongchun Xia & Hongfei Duan, 2017. "Reduction of Stress Acting on a Thick, Deep Coal Seam by Protective-Seam Mining," Energies, MDPI, vol. 10(8), pages 1-15, August.
    4. Guo, Yong & Yang, Fuqiang, 2023. "Mining safety research in China: Understanding safety research trends and future demands for sustainable mining industry," Resources Policy, Elsevier, vol. 83(C).
    5. Fangtian Wang & Cun Zhang & Ningning Liang, 2017. "Gas Permeability Evolution Mechanism and Comprehensive Gas Drainage Technology for Thin Coal Seam Mining," Energies, MDPI, vol. 10(9), pages 1-18, September.
    6. Lifeng Wu & Sifeng Liu & Ding Chen & Ligen Yao & Wei Cui, 2014. "Using gray model with fractional order accumulation to predict gas emission," Natural Hazards: Journal of the International Society for the Prevention and Mitigation of Natural Hazards, Springer;International Society for the Prevention and Mitigation of Natural Hazards, vol. 71(3), pages 2231-2236, April.
    7. Zi-shan Gao & Chuan-jie Zhu & Xi-miao Lu & Jie Ren, 2020. "Prevention and control of abnormal gas emission caused by accidental discharge of floor fissure water: a case study," Natural Hazards: Journal of the International Society for the Prevention and Mitigation of Natural Hazards, Springer;International Society for the Prevention and Mitigation of Natural Hazards, vol. 100(2), pages 713-733, January.
    8. Jun Lu & Yun Wang & Jingyi Chen, 2018. "Detection of Tectonically Deformed Coal Using Model-Based Joint Inversion of Multi-Component Seismic Data," Energies, MDPI, vol. 11(4), pages 1-17, April.
    9. Xu, Chao & Ma, Sibo & Wang, Kai & Yang, Gang & Zhou, Xin & Zhou, Aitao & Shu, Longyong, 2023. "Stress and permeability evolution of high-gassy coal seams for repeated mining," Energy, Elsevier, vol. 284(C).
    10. Zhanshan Shi & Donglin Ye & Bing Qin & Jianfeng Hao & Weiji Sun & Shengjie Fang, 2022. "Mining Height Effect and Application of Upper Protected Layer Mining Pressure Relief," Sustainability, MDPI, vol. 14(16), pages 1-18, August.
    11. Siwen Zheng & Liang Wang & Dapeng Chen & Yuanyuan Liu & Changbao Jiang, 2024. "Main control factors of coalbed methane occurrence differences in adjacent coal seams - a case study of Luling coal mine, Huaibei Coalfield, China," Natural Hazards: Journal of the International Society for the Prevention and Mitigation of Natural Hazards, Springer;International Society for the Prevention and Mitigation of Natural Hazards, vol. 120(12), pages 11183-11207, September.
    12. Yanjiang Chai & Linming Dou & Jiang He & Xiaotao Ma & Fangzhou Lu & Hu He, 2024. "Limitations of Upper Protective Layers as Pressure Relief Measures for Extra-Thick Coal Seam Mining: Insights from a Case Study," Energies, MDPI, vol. 17(6), pages 1-20, March.
    13. Feng Zhang & Jinshan Zhang, 2022. "Research on Joint Protection Layers and Gas Prevention Technology in Outburst Coal Seams," Sustainability, MDPI, vol. 14(14), pages 1-15, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:14:y:2022:i:16:p:10068-:d:888075. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.