IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v14y2022i10p5950-d815425.html
   My bibliography  Save this article

Analysis of the Dynamic Characteristics of the Top Flange Pile Driving Process of a Novel Monopile Foundation without a Transition Section

Author

Listed:
  • Ying Li

    (Chinese-German Institute of Engineering, Zhejiang University of Science and Technology, Hangzhou 310023, China)

  • Jinghui Li

    (Deep Water Engineering Research Center, Dalian University of Technology, Dalian 116024, China)

  • Wei Shi

    (Deep Water Engineering Research Center, Dalian University of Technology, Dalian 116024, China)

  • Xin Li

    (School of Hydraulic Engineering, Dalian University of Technology, Dalian 116024, China)

  • Bin Wang

    (Key Laboratory of Far-Shore Wind Power Technology of Zhejiang Province, Hangzhou 311122, China
    PowerChina Huadong Engineering Corporation Limited, Hangzhou 311122, China)

Abstract

As the most widely used foundation type, the pile-driving capacity of large-diameter monopile foundations and the hammer force of pile top flanges is increasing, as are the stress and strain of traditional flange structures under the resistance to the cyclic impact load of pile hammers. This paper conducts an empirical study on the Rudong 150 MW offshore wind farm project in Longyuan, Jiangsu Province. The numerical simulation and calculation method of large-diameter pile fatigue damage is mastered and proposed, and a simulation analysis and comparison is conducted, as is an analysis of the sensitivity and feedback of the key software parameters. Based on the results of the above analysis, a pile simulation analysis of the offshore wind power projects under construction and those that are about to be started is performed. The pile hammer stroke energy and pile top hammer stroke process curve are extracted. According to the time range curve of limit and hammer stroke forces, the flange limit stress and distribution of the pile roof are simulated. Combined with the process characteristics of large-diameter pile sinking and analysis in the case of high hammer energy and high acceleration, the effect of the impact on the sensor is discussed. The results show that the instantaneous loading analysis could load at the flange of the pile, the maximum instantaneous stress was above 500 MPa, and the final maximum stress was approximately 307 MPa. Different loading methods vary greatly in the calculation results of the structure, so choosing the appropriate loading simulation method is key to pile sinking analysis.

Suggested Citation

  • Ying Li & Jinghui Li & Wei Shi & Xin Li & Bin Wang, 2022. "Analysis of the Dynamic Characteristics of the Top Flange Pile Driving Process of a Novel Monopile Foundation without a Transition Section," Sustainability, MDPI, vol. 14(10), pages 1-12, May.
    • Handle: RePEc:gam:jsusta:v:14:y:2022:i:10:p:5950-:d:815425
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/14/10/5950/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/14/10/5950/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zeng, Xinmeng & Shi, Wei & Michailides, Constantine & Zhang, Songhao & Li, Xin, 2021. "Numerical and experimental investigation of breaking wave forces on a monopile-type offshore wind turbine," Renewable Energy, Elsevier, vol. 175(C), pages 501-519.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Jeongsoo Kim & Yeon-Ju Jeong & Joonsang Park & Ju-Hyung Lee & Taeyoung Kwak & Jae-Hyun Kim, 2022. "Experimental and Finite Element-Based Investigation on Lateral Behaviors of a Novel Hybrid Monopile," Energies, MDPI, vol. 15(23), pages 1-21, November.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zeng, Xinmeng & Shao, Yanlin & Feng, Xingya & Xu, Kun & Jin, Ruijia & Li, Huajun, 2024. "Nonlinear hydrodynamics of floating offshore wind turbines: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 191(C).
    2. Shan Liu & Zhenyu Liu, 2022. "Influence of Currents on the Breaking Wave Forces Acting on Monopiles over an Impermeable Slope," Sustainability, MDPI, vol. 15(1), pages 1-14, December.
    3. Zhu, Kai & Cao, Feifei & Wang, Tianyuan & Tao, Ji & Wei, Zhiwen & Shi, Hongda, 2024. "A comparative investigation into the dynamic performance of multiple wind-wave hybrid systems utilizing a full-process analytical model," Applied Energy, Elsevier, vol. 360(C).
    4. Zhang, Zhihao & Kuang, Limin & Han, Zhaolong & Zhou, Dai & Zhao, Yongsheng & Bao, Yan & Duan, Lei & Tu, Jiahuang & Chen, Yaoran & Chen, Mingsheng, 2023. "Comparative analysis of bent and basic winglets on performance improvement of horizontal axis wind turbines," Energy, Elsevier, vol. 281(C).
    5. Qin, Mengfei & Shi, Wei & Chai, Wei & Fu, Xing & Li, Lin & Li, Xin, 2023. "Extreme structural response prediction and fatigue damage evaluation for large-scale monopile offshore wind turbines subject to typhoon conditions," Renewable Energy, Elsevier, vol. 208(C), pages 450-464.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:14:y:2022:i:10:p:5950-:d:815425. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.