IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v18y2025i4p813-d1587569.html
   My bibliography  Save this article

Experimental Investigation of Deposition of Silica Nanocolloids by Depressurizing Supercritical Water Vapor

Author

Listed:
  • Silje Bordvik

    (Department of Energy and Process Technology, Norwegian University of Science and technology (NTNU), Kolbjørn Hejes vei 1D, 7034 Trondheim, Norway)

  • Morten Tjelta

    (Corrosion Technology Department, Institute for Energy Technology (IFE), Instituttveien 18, 2007 Kjeller, Norway)

  • Erling Næss

    (Department of Energy and Process Technology, Norwegian University of Science and technology (NTNU), Kolbjørn Hejes vei 1D, 7034 Trondheim, Norway)

Abstract

This article presents the results of an experimental investigation of silica deposition from depressurized supercritical steam. The case investigated is relevant for supercritical geothermal reservoirs with high temperature and pressure, where silica content is significant and deposition occurs rapidly upon depressurization. The purpose of the presented experiments is to accurately measure the deposited mass in two different areas in a flow tube and mathematically relate the measurement to particle formation behavior. In addition, SEM analysis permits valuable insight into the morphology of the scale formed under these conditions. The measured deposition is caused by silica solids formed when depressurizing supercritical fluids from around 350 bar and 500 °C by an isenthalpic valve to a state of superheated steam and pressures ranging from 60 to 150 bar. A test rig was designed, fabricated, and used for this purpose. The deposition mechanisms differ from silica particle formation in the water phase and the limited experimental research for the investigated conditions makes the gathered data highly interesting. The measured results are compared to validated models for deposition in straight pipes. The knowledge obtained on silica solidification and deposition can be used to optimize steam treatment of high-temperature pressurized geothermal sources for maximum power utilization by aiding in the development of advanced prediction tools for scaling and mineral extraction.

Suggested Citation

  • Silje Bordvik & Morten Tjelta & Erling Næss, 2025. "Experimental Investigation of Deposition of Silica Nanocolloids by Depressurizing Supercritical Water Vapor," Energies, MDPI, vol. 18(4), pages 1-25, February.
    • Handle: RePEc:gam:jeners:v:18:y:2025:i:4:p:813-:d:1587569
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/18/4/813/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/18/4/813/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Silje Bordvik & Titus S. van Erp & Seniz Ucar & Erling Næss, 2023. "Predicting Silica Deposition from Superheated, Pressurized Steam Using Numerical Modeling of Nucleation, Agglomeration and Deposition," Energies, MDPI, vol. 16(19), pages 1-20, September.
    2. Silje Bordvik & Erling Næss, 2023. "Silica Nanoparticle Formation from Supercritical Geothermal Sources," Energies, MDPI, vol. 16(16), pages 1-18, August.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Lodin Ellingsen & Tore Haug-Warberg, 2024. "Thermodynamics of Halite Scaling in Superhot Geothermal Systems," Energies, MDPI, vol. 17(12), pages 1-10, June.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:18:y:2025:i:4:p:813-:d:1587569. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.