IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i16p4169-d1460917.html
   My bibliography  Save this article

Simulation Study on the Heat Transfer Characteristics of Oil Shale under Different In Situ Pyrolysis Methods Based on CT Digital Rock Cores

Author

Listed:
  • Yuxing Zhang

    (Key Laboratory of In Situ Property Improving Mining of Ministry of Education, Taiyuan University of Technology, Taiyuan 030024, China)

  • Dong Yang

    (Key Laboratory of In Situ Property Improving Mining of Ministry of Education, Taiyuan University of Technology, Taiyuan 030024, China)

Abstract

To analyze the heat transfer characteristics of oil shale under different in situ pyrolysis methods from a microscopic perspective, a combination of experimental and simulation approaches was employed. Initially, high-temperature in situ pyrolysis experiments on single-fracture oil shale were conducted using high-temperature steam and electrical methods. Subsequently, micro-CT scanning technology was utilized to obtain digital rock cores under different in situ pyrolysis conditions. Finally, these digital rock cores were seamlessly integrated with COMSOL 6.0 to achieve numerical simulations of high-temperature steam convective heating and electrical conductive heating in the in situ state. The relevant conclusions are as follows: Firstly, during the in situ pyrolysis of oil shale with high-temperature steam convective heating, the overall temperature increase is uniform and orderly. Heat is conducted gradually from the pores and fractures to the matrix. The uneven distribution of pores and fractures causes an uneven temperature field, but no localized overheating occurs, which can effectively enhance the pyrolysis efficiency. Secondly, the heat transfer direction in electrical conductive heating is primarily inward along the normal direction of the heat source end face. The closer the section is to the heat source end face, the higher the rate of temperature increase. Within 1 s, the temperature rise at 100 μm (near the heat source end face) is 2.27 times that at 500 μm (near the farthest cross-section from the heat source end face). The heat transfer effect of high-temperature steam convective heating consistently surpasses that of electrical conductive heating. The T c value initially increases and then decreases as pyrolysis progresses, reaching a maximum of 1.61331 at 0.4 s, but T c remains greater than 1 throughout. Finally, in the initial stages of pyrolysis, the high-temperature region formed by conductive heating is superior to that of convective heating. However, once the heat carrier fluid flow stabilizes, the volume of the high-temperature region formed by convective heating grows rapidly compared to that of conductive heating. At 1 s, the volume of the high-temperature region formed by convective heating reaches 5.22 times that of the high-temperature region formed by conductive heating.

Suggested Citation

  • Yuxing Zhang & Dong Yang, 2024. "Simulation Study on the Heat Transfer Characteristics of Oil Shale under Different In Situ Pyrolysis Methods Based on CT Digital Rock Cores," Energies, MDPI, vol. 17(16), pages 1-21, August.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:16:p:4169-:d:1460917
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/16/4169/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/16/4169/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Kang, Zhiqin & Jiang, Xing & Wang, Lei & Yang, Dong & Ma, Yulin & Zhao, Yangsheng, 2023. "Comparative investigation of in situ hydraulic fracturing and high-temperature steam fracturing tests for meter-scale oil shale," Energy, Elsevier, vol. 281(C).
    2. Kang, Zhiqin & Zhao, Yangsheng & Yang, Dong, 2020. "Review of oil shale in-situ conversion technology," Applied Energy, Elsevier, vol. 269(C).
    3. Saif, Tarik & Lin, Qingyang & Gao, Ying & Al-Khulaifi, Yousef & Marone, Federica & Hollis, David & Blunt, Martin J. & Bijeljic, Branko, 2019. "4D in situ synchrotron X-ray tomographic microscopy and laser-based heating study of oil shale pyrolysis," Applied Energy, Elsevier, vol. 235(C), pages 1468-1475.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Pan, Bin & Yin, Xia & Yang, Zhengru & Ghanizadeh, Amin & Debuhr, Chris & Clarkson, Christopher R. & Gou, Feifei & Zhu, Weiyao & Ju, Yang & Iglauer, Stefan, 2024. "Real-time imaging of oil shale pyrolysis dynamics at nanoscale via environmental scanning electron microscopy," Applied Energy, Elsevier, vol. 363(C).
    2. Niu, Daming & Sun, Pingchang & Ma, Lin & Zhao, Kang'an & Ding, Cong, 2023. "Porosity evolution of Minhe oil shale under an open rapid heating system and the carbon storage potentials," Renewable Energy, Elsevier, vol. 205(C), pages 783-799.
    3. Cui, Ziang & Sun, Mengdi & Mohammadian, Erfan & Hu, Qinhong & Liu, Bo & Ostadhassan, Mehdi & Yang, Wuxing & Ke, Yubin & Mu, Jingfu & Ren, Zijie & Pan, Zhejun, 2024. "Characterizing microstructural evolutions in low-mature lacustrine shale: A comparative experimental study of conventional heat, microwave, and water-saturated microwave stimulations," Energy, Elsevier, vol. 294(C).
    4. Kang, Zhiqin & Jiang, Xing & Wang, Lei & Yang, Dong & Ma, Yulin & Zhao, Yangsheng, 2023. "Comparative investigation of in situ hydraulic fracturing and high-temperature steam fracturing tests for meter-scale oil shale," Energy, Elsevier, vol. 281(C).
    5. Shangli Liu & Haifeng Gai & Peng Cheng, 2023. "Technical Scheme and Application Prospects of Oil Shale In Situ Conversion: A Review of Current Status," Energies, MDPI, vol. 16(11), pages 1-22, May.
    6. Zhan, Honglei & Yang, Qi & Qin, Fankai & Meng, Zhaohui & Chen, Ru & Miao, Xinyang & Zhao, Kun & Yue, Wenzheng, 2022. "Comprehensive preparation and multiscale characterization of kerogen in oil shale," Energy, Elsevier, vol. 252(C).
    7. Lei, Jian & Pan, Baozhi & Guo, Yuhang & Fan, YuFei & Xue, Linfu & Deng, Sunhua & Zhang, Lihua & Ruhan, A., 2021. "A comprehensive analysis of the pyrolysis effects on oil shale pore structures at multiscale using different measurement methods," Energy, Elsevier, vol. 227(C).
    8. Dazhong Ren & Zhendong Wang & Fu Yang & Hao Zeng & Chenyuan Lü & Han Wang & Senhao Wang & Shaotao Xu, 2024. "Study on the Applicability of Autothermic Pyrolysis In Situ Conversion Process for Low-Grade Oil Shale: A Case Study of Tongchuan, Ordos Basin, China," Energies, MDPI, vol. 17(13), pages 1-21, June.
    9. Zhan, Honglei & Qin, Fankai & Chen, Sitong & Chen, Ru & Meng, Zhaohui & Miao, Xinyang & Zhao, Kun, 2022. "Two-step pyrolysis degradation mechanism of oil shale through comprehensive analysis of pyrolysis semi-cokes and pyrolytic gases," Energy, Elsevier, vol. 241(C).
    10. Wang, Lei & Yang, Dong & Zhang, Yuxing & Li, Wenqing & Kang, Zhiqin & Zhao, Yangsheng, 2022. "Research on the reaction mechanism and modification distance of oil shale during high-temperature water vapor pyrolysis," Energy, Elsevier, vol. 261(PB).
    11. Jin, Xu & Wang, Xiaoqi & Yan, Weipeng & Meng, Siwei & Liu, Xiaodan & Jiao, Hang & Su, Ling & Zhu, Rukai & Liu, He & Li, Jianming, 2019. "Exploration and casting of large scale microscopic pathways for shale using electrodeposition," Applied Energy, Elsevier, vol. 247(C), pages 32-39.
    12. Youhong Sun & Shichang Liu & Qiang Li & Xiaoshu Lü, 2022. "Experimental Study on the Factors of the Oil Shale Thermal Breakdown in High-Voltage Power Frequency Electric Heating Technology," Energies, MDPI, vol. 15(19), pages 1-12, September.
    13. Lianhua Hou & Zhongying Zhao & Xia Luo & Jingkui Mi & Zhenglian Pang & Lijun Zhang & Senhu Lin, 2024. "Evaluation of Recoverable Hydrocarbon Reserves and Area Selection Methods for In Situ Conversion of Shale," Energies, MDPI, vol. 17(11), pages 1-24, June.
    14. Wang, Guoying & Liu, Shaowei & Yang, Dong & Fu, Mengxiong, 2022. "Numerical study on the in-situ pyrolysis process of steeply dipping oil shale deposits by injecting superheated water steam: A case study on Jimsar oil shale in Xinjiang, China," Energy, Elsevier, vol. 239(PC).
    15. Shi, Yu & Zhang, Yulong & Song, Xianzhi & Cui, Qiliang & Lei, Zhihong & Song, Guofeng, 2023. "Injection energy utilization efficiency and production performance of oil shale in-situ exploitation," Energy, Elsevier, vol. 263(PB).
    16. Huang, Xianfu & Zhao, Ya-Pu, 2023. "Evolution of pore structure and adsorption-desorption in oil shale formation rocks after compression," Energy, Elsevier, vol. 278(PA).
    17. Aman Turakhanov & Albina Tsyshkova & Elena Mukhina & Evgeny Popov & Darya Kalacheva & Ekaterina Dvoretskaya & Anton Kasyanenko & Konstantin Prochukhan & Alexey Cheremisin, 2021. "Cyclic Subcritical Water Injection into Bazhenov Oil Shale: Geochemical and Petrophysical Properties Evolution Due to Hydrothermal Exposure," Energies, MDPI, vol. 14(15), pages 1-16, July.
    18. Zhou, Guangzhao & Guo, Zanquan & Sun, Simin & Jin, Qingsheng, 2023. "A CNN-BiGRU-AM neural network for AI applications in shale oil production prediction," Applied Energy, Elsevier, vol. 344(C).
    19. Chunsheng Yu & Xiao Zhao & Qi Jiang & Xiaosha Lin & Hengyuan Gong & Xuanqing Chen, 2022. "Shale Microstructure Characteristics under the Action of Supercritical Carbon Dioxide (Sc-CO 2 )," Energies, MDPI, vol. 15(22), pages 1-9, November.
    20. Hao Wang & Xiaogang Li & Jingyi Zhu & Zhaozhong Yang & Jie Zhou & Liangping Yi, 2022. "Numerical Simulation of Oil Shale Pyrolysis under Microwave Irradiation Based on a Three-Dimensional Porous Medium Multiphysics Field Model," Energies, MDPI, vol. 15(9), pages 1-20, April.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:16:p:4169-:d:1460917. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.