IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i21p7441-d1273992.html
   My bibliography  Save this article

Simulation Research on the Optimization of Domestic Heat Pump Water Heater Condensers

Author

Listed:
  • Yang Han

    (School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong 723001, China)

  • Rong Feng

    (School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong 723001, China)

  • Taiyang Xiao

    (School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong 723001, China)

  • Machao Guo

    (School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong 723001, China)

  • Jiahui Wu

    (School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong 723001, China)

  • Hong Cui

    (School of Mechanical Engineering, Shaanxi University of Technology, Hanzhong 723001, China)

Abstract

To improve the heat transfer coefficient of a condenser, this paper proposes using a fin-tube condenser to replace a smooth-tube condenser in a domestic heat pump water heater. The finite element method is used to analyze the heat transfer coefficient of fin-tube condensers with different design parameters. By comparing the results of experiments with those obtained using CFD methods, it has been determined that the CFD method used in this study is feasible. Simulation results showed that the heat transfer coefficient enhanced clearly. The total thermal resistance of the fin-tube condenser decreased by 7% through increasing fin thickness. The total thermal resistance of the fin-tube condenser increased by 1–1.3% when fin spacing was increased. The heat transfer coefficient decreased severely and the maximum total thermal resistance of the fin-tube condenser increased by 8.7% with increasing fin height. In 600 s, when the fin spacing, fin height, fin thickness and inner diameter were 14 mm, 12.5 mm, 1.2 mm and 22.5 mm, respectively, compared to the smooth-tube condenser, the fin-tube condenser could increase the final water temperature by 18.37%, and the heat transfer coefficient would increase by about 95%. This research could provide a low-cost way to improve the heat transfer coefficient of condensers in domestic heat pump water heaters.

Suggested Citation

  • Yang Han & Rong Feng & Taiyang Xiao & Machao Guo & Jiahui Wu & Hong Cui, 2023. "Simulation Research on the Optimization of Domestic Heat Pump Water Heater Condensers," Energies, MDPI, vol. 16(21), pages 1-14, November.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:21:p:7441-:d:1273992
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/21/7441/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/21/7441/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Dizaji, Hamed Sadighi & Pourhedayat, Samira & Aldawi, Fayez & Moria, Hazim & Anqi, Ali E. & Jarad, Fahd, 2022. "Proposing an innovative and explicit economic criterion for all passive heat transfer enhancement techniques of heat exchangers," Energy, Elsevier, vol. 239(PC).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Liu, Hanyu & Xi, Kun & Xie, Zhihui & Lu, Zhuoqun & Chen, Huawei & Zhang, Jian & Ge, Yanlin, 2023. "Constructal design of double-layer asymmetric flower baffles," Energy, Elsevier, vol. 280(C).
    2. Dizaji, Hamed Sadighi & Pourhedayat, Samira & Moria, Hazim & Alqahtani, Sultan & Alshehery, Sultan & Anqi, Ali E., 2024. "Performance boost of a commercial air-to-air plate heat recovery unit by mesh-net insert; thermal-frictional, economic, and effectiveness-NTU analysis," Energy, Elsevier, vol. 290(C).
    3. Xin, Feng & Tang, Bin & Zhao, Bin & Yang, Yanfeng & Liu, Wei & Liu, Zhichun, 2024. "Heat transfer enhancement of a Stirling engine heating tube with three-pronged slant rods under oscillatory flow," Energy, Elsevier, vol. 301(C).
    4. Keçebaş, Ali & Georgiev, Aleksandar G. & Karaca-Dolgun, Gülşah, 2024. "Exergy and exergoenvironmental analyses for characterizing heat transfer and pressure drop of any heat exchanger," Energy, Elsevier, vol. 290(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:21:p:7441-:d:1273992. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.