IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i9p3234-d804595.html
   My bibliography  Save this article

Friction Factor and Heat Transfer of Giesekus-Fluid-Based Nanofluids in a Pipe Flow

Author

Listed:
  • Wenqian Lin

    (School of Media and Design, Hangzhou Dianzi University, Hangzhou 310018, China)

  • Hailin Yang

    (State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou 310027, China)

  • Jianzhong Lin

    (State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou 310027, China
    Laboratory of Impact and Safety Engineering (Ningbo University), Ministry of Education, Ningbo 315201, China)

Abstract

The friction factor and heat transfer of Giesekus-fluid-based nanofluids in a pipe flow were studied in the ranges of 0.5 ≤ Reynolds number (Re) ≤ 500, 1 ≤ Weissenberg number (Wi) ≤ 8, 0.5% ≤ particle volume concentration ( Φ ) ≤ 3.0%, 0 ≤ viscosity ratio ( β 0 ) ≤ 1, and 0 ≤ mobility parameter ( α ) ≤ 0.5. Our numerical method was validated by comparing the results with available ones in the literature. The effects of Wi, Φ , β 0 , Re, and α on the relative friction factor ( C f / C f New ), Nusselt number (Nu), and ratio (PEC nf /PEC f ) of energy performance evaluation criterion for Giesekus-fluid-based nanofluids to those for Giesekus fluid were discussed. The results showed that the values for the C f / C f New and Nu of Giesekus-fluid-based nanofluids were larger than those for Newtonian fluid-based nanofluids and those for pure Giesekus fluid. The values for C f / C f New increased with increasing Φ and Re, but they increased with decreasing β 0 and α . As Wi increased, the values of C f / C f New first increased and then decreased. The values of Nu and PEC nf /PEC f were enhanced with increasing Wi, Φ , Re, and α , but with decreasing β 0 . It is more effective to use Giesekus-fluid-based nanofluids to improve heat transfer with the conditions of a larger Wi, Φ , Re, and α and a smaller β 0 . Finally, the correlation formula for PEC nf /PEC f as a function of Wi, Φ , β 0 , Re, and α was derived.

Suggested Citation

  • Wenqian Lin & Hailin Yang & Jianzhong Lin, 2022. "Friction Factor and Heat Transfer of Giesekus-Fluid-Based Nanofluids in a Pipe Flow," Energies, MDPI, vol. 15(9), pages 1-16, April.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:9:p:3234-:d:804595
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/9/3234/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/9/3234/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Xin Chang & Jun Zhou & Yintong Guo & Shiming He & Lei Wang & Yulin Chen & Ming Tang & Rui Jian, 2018. "Heat Transfer Behaviors in Horizontal Wells Considering the Effects of Drill Pipe Rotation, and Hydraulic and Mechanical Frictions during Drilling Procedures," Energies, MDPI, vol. 11(9), pages 1-28, September.
    2. M. Sulaiman & Aamir Ali & S. Islam, 2018. "Heat and Mass Transfer in Three-Dimensional Flow of an Oldroyd-B Nanofluid with Gyrotactic Micro-Organisms," Mathematical Problems in Engineering, Hindawi, vol. 2018, pages 1-15, September.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zahra Shah Hosseini & Awatef Abidi & Sajad Mohammadi & Seyed Abdollah Mansouri Mehryan & Christopher Hulme, 2021. "A Fully Resolved Computational Fluid Dynamics Study of the Boundary Layer Flow of an Aqueous Nanoliquid Comprising Gyrotactic Microorganisms over a Stretching Sheet: The Validity of Conventional Simil," Mathematics, MDPI, vol. 9(21), pages 1-18, October.
    2. Xiao, Dong & Xiao, Hongyu & Song, Wei & Li, Gao & Zhang, Jie & Deng, Hu & Guo, Boyun & Tang, Gui & Duan, Mubai & Tang, Haijun, 2024. "Utilization method of low-grade thermal energy during drilling based on insulated Drill pipe," Renewable Energy, Elsevier, vol. 225(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:9:p:3234-:d:804595. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.