IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i4p1025-d500058.html
   My bibliography  Save this article

Investigation of Environmental Leaching Behavior of an Innovative Method for Landfilling of Waste Incineration Air Pollution Control Residues

Author

Listed:
  • Mihail Reinhold Wächter

    (Faculty of Mechanical Engineering, Polytehnic University Timişoara, Mihai Viteazu Blvd., No. 1, 300222 Timişoara, Romania)

  • Ioana Ionel

    (Faculty of Mechanical Engineering, Polytehnic University Timişoara, Mihai Viteazu Blvd., No. 1, 300222 Timişoara, Romania)

  • Daniel Dan

    (Faculty for Civil Engineering, Polytehnic University Timişoara, Traian Lalescu, No. 2, 300223 Timişoara, Romania)

  • Adina Negrea

    (Faculty of Industrial Chemistry and Environmental Engineering, Polytehnic University Timişoara, Vasile Parvan Blvd., No. 6, 300223 Timişoara, Romania)

Abstract

Waste incineration air pollution control (APC) residues require pretreatment before landfilling because these types of residues encompass pollutants from an incineration gas stream. The environmental concerns of APC residues consist of a risk of leaching and subsequent release of potentially harmful substances that occur under environmental exposure. The stabilization/solidification (S/S) method of incineration residues is one of the most applied technologies for hazardous incineration residues. Portland cement is commonly used as a binder material in S/S for pollutant encapsulation, in order to change the hydrological characteristics of the landfilled material. Based on previous research, an innovative S/S method for APC residues is investigated, meant to replace Portland cement with cement-like material made from lignite fly ash (FA). To do this, a lab-scale landfill was created through the promoted S/S method and exposed to the environment for 12 months. Thus, this article assesses the lab-scale leaching behavior of a landfill disposal material exposed to environmental conditions and attempts to prove the promoted innovative S/S method. The results show that the replacement of Portland cement with a substitute material for utilization in the S/S method can mitigate energy consumption in the industrial cement subsector.

Suggested Citation

  • Mihail Reinhold Wächter & Ioana Ionel & Daniel Dan & Adina Negrea, 2021. "Investigation of Environmental Leaching Behavior of an Innovative Method for Landfilling of Waste Incineration Air Pollution Control Residues," Energies, MDPI, vol. 14(4), pages 1-10, February.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:4:p:1025-:d:500058
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/4/1025/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/4/1025/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Madlool, N.A. & Saidur, R. & Hossain, M.S. & Rahim, N.A., 2011. "A critical review on energy use and savings in the cement industries," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(4), pages 2042-2060, May.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Liu, Xuewei & Yuan, Zengwei & Xu, Yuan & Jiang, Songyan, 2017. "Greening cement in China: A cost-effective roadmap," Applied Energy, Elsevier, vol. 189(C), pages 233-244.
    2. Vélez, Fredy & Segovia, José J. & Martín, M. Carmen & Antolín, Gregorio & Chejne, Farid & Quijano, Ana, 2012. "A technical, economical and market review of organic Rankine cycles for the conversion of low-grade heat for power generation," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(6), pages 4175-4189.
    3. Talaei, Alireza & Pier, David & Iyer, Aishwarya V. & Ahiduzzaman, Md & Kumar, Amit, 2019. "Assessment of long-term energy efficiency improvement and greenhouse gas emissions mitigation options for the cement industry," Energy, Elsevier, vol. 170(C), pages 1051-1066.
    4. Madlool, N.A. & Saidur, R. & Rahim, N.A. & Kamalisarvestani, M., 2013. "An overview of energy savings measures for cement industries," Renewable and Sustainable Energy Reviews, Elsevier, vol. 19(C), pages 18-29.
    5. Xiao, Yihao & Xue, Yahui, 2024. "A review on application of microwave in cement life cycle," Renewable and Sustainable Energy Reviews, Elsevier, vol. 199(C).
    6. Huang, Yun-Hsun & Chang, Yi-Lin & Fleiter, Tobias, 2016. "A critical analysis of energy efficiency improvement potentials in Taiwan's cement industry," Energy Policy, Elsevier, vol. 96(C), pages 14-26.
    7. Thirugnanasambandam, M. & Hasanuzzaman, M. & Saidur, R. & Ali, M.B. & Rajakarunakaran, S. & Devaraj, D. & Rahim, N.A., 2011. "Analysis of electrical motors load factors and energy savings in an Indian cement industry," Energy, Elsevier, vol. 36(7), pages 4307-4314.
    8. Gao, Tianming & Shen, Lei & Shen, Ming & Liu, Litao & Chen, Fengnan & Gao, Li, 2017. "Evolution and projection of CO2 emissions for China's cement industry from 1980 to 2020," Renewable and Sustainable Energy Reviews, Elsevier, vol. 74(C), pages 522-537.
    9. Mikulčić, Hrvoje & Vujanović, Milan & Duić, Neven, 2013. "Reducing the CO2 emissions in Croatian cement industry," Applied Energy, Elsevier, vol. 101(C), pages 41-48.
    10. Lin, Boqiang & Ouyang, Xiaoling, 2014. "Electricity demand and conservation potential in the Chinese nonmetallic mineral products industry," Energy Policy, Elsevier, vol. 68(C), pages 243-253.
    11. Dovile Rubinaite & Tadas Dambrauskas & Kestutis Baltakys & Raimundas Siauciunas, 2023. "Effect of Hydrothermal Curing on the Hydration and Strength Development of Belite Cement Mortar Containing Industrial Wastes," Sustainability, MDPI, vol. 15(12), pages 1-13, June.
    12. Ahamed, J.U. & Madlool, N.A. & Saidur, R. & Shahinuddin, M.I. & Kamyar, A. & Masjuki, H.H., 2012. "Assessment of energy and exergy efficiencies of a grate clinker cooling system through the optimization of its operational parameters," Energy, Elsevier, vol. 46(1), pages 664-674.
    13. Pan, Lisheng & Guo, Yuan & Mu, Bai & Shi, Weixiu & Wei, Xiaolin, 2024. "Operation optimization of cement clinker production line based on neural network and genetic algorithm," Energy, Elsevier, vol. 303(C).
    14. Grzegorz Ludwik Golewski, 2020. "Energy Savings Associated with the Use of Fly Ash and Nanoadditives in the Cement Composition," Energies, MDPI, vol. 13(9), pages 1-20, May.
    15. BoroumandJazi, G. & Rismanchi, B. & Saidur, R., 2013. "A review on exergy analysis of industrial sector," Renewable and Sustainable Energy Reviews, Elsevier, vol. 27(C), pages 198-203.
    16. Zhang, Shaohui & Worrell, Ernst & Crijns-Graus, Wina, 2015. "Evaluating co-benefits of energy efficiency and air pollution abatement in China’s cement industry," Applied Energy, Elsevier, vol. 147(C), pages 192-213.
    17. Cao, Zhi & Shen, Lei & Zhao, Jianan & Liu, Litao & Zhong, Shuai & Yang, Yan, 2016. "Modeling the dynamic mechanism between cement CO2 emissions and clinker quality to realize low-carbon cement," Resources, Conservation & Recycling, Elsevier, vol. 113(C), pages 116-126.
    18. Yin, Qian & Du, Wen-Jing & Ji, Xing-Lin & Cheng, Lin, 2016. "Optimization design and economic analyses of heat recovery exchangers on rotary kilns," Applied Energy, Elsevier, vol. 180(C), pages 743-756.
    19. Mostafavi Sani, Mostafa & Noorpoor, Alireza & Shafie-Pour Motlagh, Majid, 2019. "Optimal model development of energy hub to supply water, heating and electrical demands of a cement factory," Energy, Elsevier, vol. 177(C), pages 574-592.
    20. Abriyantoro, Dedi & Dong, Jingxin & Hicks, Christian & Singh, Surya P., 2019. "A stochastic optimisation model for biomass outsourcing in the cement manufacturing industry with production planning constraints," Energy, Elsevier, vol. 169(C), pages 515-526.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:4:p:1025-:d:500058. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.