IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i2p268-d475539.html
   My bibliography  Save this article

Impact of Dropwise Condensation on the Biomass Production Rate in Covered Raceway Ponds

Author

Listed:
  • Jack Hoeniges

    (Mechanical and Aerospace Engineering Department, Henry Samueli School of Engineering and Applied Science, University of California, Los Angeles, CA 90095, USA
    Université de Nantes, Oniris, CNRS, GEPEA, UMR 6144, F-44600 Saint-Nazaire, France)

  • Keyong Zhu

    (School of Aeronautical Science and Engineering, Beihang University, Beijing 100191, China)

  • Jeremy Pruvost

    (Université de Nantes, Oniris, CNRS, GEPEA, UMR 6144, F-44600 Saint-Nazaire, France)

  • Jack Legrand

    (Université de Nantes, Oniris, CNRS, GEPEA, UMR 6144, F-44600 Saint-Nazaire, France)

  • El-khider Si-Ahmed

    (Université de Nantes, Oniris, CNRS, GEPEA, UMR 6144, F-44600 Saint-Nazaire, France)

  • Laurent Pilon

    (Mechanical and Aerospace Engineering Department, Henry Samueli School of Engineering and Applied Science, University of California, Los Angeles, CA 90095, USA)

Abstract

This study investigates the effect of condensed water droplets on the areal biomass productivity of outdoor culture systems with a free surface, protected by a transparent window or cover to prevent contamination and to control the growth conditions. Under solar radiation, evaporation from the culture causes droplets to condense on the interior surface of the cover. To quantify the effect of droplets on the system’s performance, the bidirectional transmittance of a droplet-covered window was predicted using the Monte Carlo ray-tracing method. It was combined with a growth kinetics model of Chlorella vulgaris to predict the temporal evolution of the biomass concentration on 21 June and 23 September in Los Angeles, CA. A droplet contact angle of 30 ∘ or 90 ∘ and a surface area coverage of 50% or 90% were considered. Light scattering by the condensed droplets changed the direction of the incident sunlight while reducing the amount of light reaching the culture by up to 37%. The combined effect decreased the daily areal biomass productivity with increasing droplet contact angle and surface area coverage by as much as 18%. Furthermore, the areal biomass productivity of the system was found to scale with the ratio X 0 / a of the initial biomass concentration X 0 and the specific illuminated area a , as previously established for different photobioreactor geometries, but even in the presence of droplets. Finally, for a given day of the year, the optical thickness of the culture that yielded the maximum productivity was independent of the window condition. Thus, the design and operation of such a system should focus on maintaining a small droplet contact angle and surface area coverage and an optimum optical thickness to maximize productivity.

Suggested Citation

  • Jack Hoeniges & Keyong Zhu & Jeremy Pruvost & Jack Legrand & El-khider Si-Ahmed & Laurent Pilon, 2021. "Impact of Dropwise Condensation on the Biomass Production Rate in Covered Raceway Ponds," Energies, MDPI, vol. 14(2), pages 1-23, January.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:2:p:268-:d:475539
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/2/268/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/2/268/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Slegers, P.M. & Wijffels, R.H. & van Straten, G. & van Boxtel, A.J.B., 2011. "Design scenarios for flat panel photobioreactors," Applied Energy, Elsevier, vol. 88(10), pages 3342-3353.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yadala, Soumya & Cremaschi, Selen, 2014. "Design and optimization of artificial cultivation units for algae production," Energy, Elsevier, vol. 78(C), pages 23-39.
    2. Behera, Bunushree & Unpaprom, Yuwalee & Ramaraj, Rameshprabu & Maniam, Gaanty Pragas & Govindan, Natanamurugaraj & Paramasivan, Balasubramanian, 2021. "Integrated biomolecular and bioprocess engineering strategies for enhancing the lipid yield from microalgae," Renewable and Sustainable Energy Reviews, Elsevier, vol. 148(C).
    3. Lucas Reijnders, 2013. "Lipid‐based liquid biofuels from autotrophic microalgae: energetic and environmental performance," Wiley Interdisciplinary Reviews: Energy and Environment, Wiley Blackwell, vol. 2(1), pages 73-85, January.
    4. Alcinda P. Lopes & Francisca M. Santos & Tânia F. C. V. Silva & Vítor J. P. Vilar & José C. M. Pires, 2020. "Outdoor Cultivation of the Microalga Chlorella vulgaris in a New Photobioreactor Configuration: The Effect of Ultraviolet and Visible Radiation," Energies, MDPI, vol. 13(8), pages 1-18, April.
    5. Behera, Bunushree & Aly, Nazimdhine & P., Balasubramanian, 2018. "Biophysical modeling of microalgal cultivation in open ponds," Ecological Modelling, Elsevier, vol. 388(C), pages 61-71.
    6. Monika Hejna & Dominika Kapuścińska & Anna Aksmann, 2022. "Pharmaceuticals in the Aquatic Environment: A Review on Eco-Toxicology and the Remediation Potential of Algae," IJERPH, MDPI, vol. 19(13), pages 1-40, June.
    7. Boruff, Bryan J. & Moheimani, Navid R. & Borowitzka, Michael A., 2015. "Identifying locations for large-scale microalgae cultivation in Western Australia: A GIS approach," Applied Energy, Elsevier, vol. 149(C), pages 379-391.
    8. Qihang Jin & Zhenzong He & Huijie Ma, 2019. "Quantitative Research of Photobioreactor Performance Based on an Improved Surface Fitting Method," Energies, MDPI, vol. 12(21), pages 1-24, October.
    9. Slegers, P.M. & van Beveren, P.J.M. & Wijffels, R.H. & van Straten, G. & van Boxtel, A.J.B., 2013. "Scenario analysis of large scale algae production in tubular photobioreactors," Applied Energy, Elsevier, vol. 105(C), pages 395-406.
    10. Kim, Sungwhan & Kim, Donghyun & Ryu, Byung-Gon & Chang, Yong Keun, 2020. "Design optimization of large-scale attached cultivation of Ettlia sp. to maximize biomass production based on simulation of solar irradiation," Applied Energy, Elsevier, vol. 279(C).
    11. Pires, José C.M. & Alvim-Ferraz, Maria C.M. & Martins, Fernando G., 2017. "Photobioreactor design for microalgae production through computational fluid dynamics: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 79(C), pages 248-254.
    12. van Boxtel, A.J.B. & Perez-Lopez, P. & Breitmayer, E. & Slegers, P.M., 2015. "The potential of optimized process design to advance LCA performance of algae production systems," Applied Energy, Elsevier, vol. 154(C), pages 1122-1127.
    13. Yang, Perry Pei-Ju & Quan, Steven Jige & Castro-Lacouture, Daniel & Stuart, Ben J., 2018. "A Geodesign method for managing a closed-loop urban system through algae cultivation," Applied Energy, Elsevier, vol. 231(C), pages 1372-1382.
    14. Nilay Kumar Sarker & Prasad Kaparaju, 2023. "A Critical Review on the Status and Progress of Microalgae Cultivation in Outdoor Photobioreactors Conducted over 35 Years (1986–2021)," Energies, MDPI, vol. 16(7), pages 1-32, March.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:2:p:268-:d:475539. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.