IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i21p7357-d672704.html
   My bibliography  Save this article

Evaluation on Coupling of Wall Boiling and Population Balance Models for Vertical Gas-Liquid Subcooled Boiling Flow of First Loop of Nuclear Power Plant

Author

Listed:
  • Guang Hu

    (Institute of Thermal Energy Technology and Safety, National Research Center of Helmholtz Association, Karlsruhe Institute of Technology, 76344 Karlsruhe, Germany)

  • Yue Ma

    (Institute of Nuclear and New Energy Technology, Key Laboratory of Advanced Reactor Engineering and Safety, Tsinghua University, Beijing 100084, China)

  • Qianfeng Liu

    (Institute of Nuclear and New Energy Technology, Key Laboratory of Advanced Reactor Engineering and Safety, Tsinghua University, Beijing 100084, China)

Abstract

An accurate prediction of the interphase behaviors of the vertical gas-liquid subcooled boiling flow is meaningful for the first loop of a nuclear power plant (NPP). Therefore, the interphase behaviors including the bubble size distribution in the first loop of the NPP are analyzed, evaluated, and validated using various wall boiling models coupled with the population balance model (PBM) kernels in this paper. Firstly, nondimensional numbers of the first loop of the NPP and DEBORA (Development of Borehole Seals for High-Level Radioactive Waste) experiment test cases are analyzed with approximation. Secondly, five active nucleation site density models N n coupled with the PBM kernel combination, four kernel combinations (C1~C4) with the N n models are calculated and analyzed. Lastly, various behaviors including the bubble size distribution Sauter mean diameter (SMD) d p , void fraction α , gas superficial velocity j g , and liquid superficial velocity j l are compared and validated with the experimental data of the DEBORA-1 ( P = 2.62 MPa). The results indicate that the two N n models are suitable for the calculations of thefirst loop of the nuclear power plant. For instance, for the bubble size distribution SMD d p , the specified N n model with C1 (maximum relative error 9.63%) has relatively better behaviors for the first loop of the NPP. Especially, the combination C1 is applicable for the calculation of the bubble size distribution d p , void fraction α and liquid superficial velocity j l while C4 is suitable for the calculation of the gas superficial velocity j g . These results can provide guidance for the numerical computation of the subcooled boiling flow in the first loop of the NPP.

Suggested Citation

  • Guang Hu & Yue Ma & Qianfeng Liu, 2021. "Evaluation on Coupling of Wall Boiling and Population Balance Models for Vertical Gas-Liquid Subcooled Boiling Flow of First Loop of Nuclear Power Plant," Energies, MDPI, vol. 14(21), pages 1-29, November.
  • Handle: RePEc:gam:jeners:v:14:y:2021:i:21:p:7357-:d:672704
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/21/7357/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/14/21/7357/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Yixiang Liao & Dirk Lucas, 2017. "Possibilities and Limitations of CFD Simulation for Flashing Flow Scenarios in Nuclear Applications," Energies, MDPI, vol. 10(1), pages 1-22, January.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Jinhu Lin & Xiaohui Zhang & Xiaoyan Huang & Luyang Chen, 2022. "Numerical Simulation Study on the Flow and Heat Transfer Characteristics of Subcooled N-Heptane Flow Boiling in a Vertical Pipe under External Radiation," Energies, MDPI, vol. 15(10), pages 1-35, May.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Alfredo Iranzo & Francisco Javier Pino & José Guerra & Francisco Bernal & Nicasio García, 2018. "Cooling Process Analysis of a 5-Drum System for Radioactive Waste Processing," Energies, MDPI, vol. 11(10), pages 1-25, October.
    2. Giacomelli, Francesco & Mazzelli, Federico & Milazzo, Adriano, 2018. "A novel CFD approach for the computation of R744 flashing nozzles in compressible and metastable conditions," Energy, Elsevier, vol. 162(C), pages 1092-1105.
    3. Bjørn H. Hjertager, 2017. "Engineering Fluid Dynamics," Energies, MDPI, vol. 10(10), pages 1-2, September.
    4. Liangyu Zhu & Tao Zhou & Xijia Ding & Xuemeng Qin & Jialei Zhang, 2019. "Study on the Movement and Deposition of Particles in Supercritical Water Natural Circulation Based on Grey Correlation Theory," Energies, MDPI, vol. 12(12), pages 1-18, June.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:21:p:7357-:d:672704. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.