IDEAS home Printed from https://ideas.repec.org/a/gam/jagris/v11y2021i4p324-d531332.html
   My bibliography  Save this article

Influence of Cooling and Heating Systems on Pen Fouling, Lying Behavior, and Performance of Rearing Piglets

Author

Listed:
  • Svenja Opderbeck

    (Institute of Agricultural Engineering, University of Hohenheim, Garbenstraße 9, 70599 Stuttgart, Germany)

  • Barbara Keßler

    (Bildungs-und Wissenzentrum Boxberg, Seehöfer Str. 50, 97944 Boxberg-Windischbuch, Germany)

  • William Gordillio

    (Bildungs-und Wissenzentrum Boxberg, Seehöfer Str. 50, 97944 Boxberg-Windischbuch, Germany)

  • Hansjörg Schrade

    (Bildungs-und Wissenzentrum Boxberg, Seehöfer Str. 50, 97944 Boxberg-Windischbuch, Germany)

  • Hans-Peter Piepho

    (Institute of Crop Science, Biostatistics Unit, University of Hohenheim, Fruwirthstr. 23, 70599 Stuttgart, Germany)

  • Eva Gallmann

    (Institute of Agricultural Engineering, University of Hohenheim, Garbenstraße 9, 70599 Stuttgart, Germany)

Abstract

The rearing of piglets is a demanding phase of pig production partly because of the changing temperature requirements of the piglets during rearing. Piglets need high temperatures in the resting area, especially at the beginning, while the optimal temperature is lower toward the end of rearing. To meet the changing temperature demands of the piglets and also to optimize the pen structure, one floor cooling and two heating systems were examined in this study. In two rearing compartments, four pens with 48 piglets each were equipped with a heated cover above a heated/cooled lying area. The lying behavior and performance of 1152 piglets, in addition to the pen fouling, were recorded over six rearing periods. There was no difference between the two heating systems in the lying behavior. However, the acceptance of the lying area was very high in all pens and periods with heating. The cooling had a significant influence on the lying behavior depending on the rearing week. Significantly more piglets lay on the cooled lying area compared with the control pen during the last weeks. The fouling of the pens was not affected by the cooling or heating systems; however, the fouling in all pens was very low. The tested pen structure in combination with a heating and cooling system is a well-functioning way of integrating a solid lying area.

Suggested Citation

  • Svenja Opderbeck & Barbara Keßler & William Gordillio & Hansjörg Schrade & Hans-Peter Piepho & Eva Gallmann, 2021. "Influence of Cooling and Heating Systems on Pen Fouling, Lying Behavior, and Performance of Rearing Piglets," Agriculture, MDPI, vol. 11(4), pages 1-14, April.
    • Handle: RePEc:gam:jagris:v:11:y:2021:i:4:p:324-:d:531332
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2077-0472/11/4/324/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2077-0472/11/4/324/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. S. Opderbeck & B. Keßler & W. Gordillio & H. Schrade & Hans-Peter Piepho & Eva Gallmann, 2020. "Influence of A Cooled, Solid Lying Area on the Pen Fouling and Lying Behavior of Fattening Pigs," Agriculture, MDPI, vol. 10(7), pages 1-19, July.
    2. Svenja Opderbeck & Barbara Keßler & William Gordillo & Hansjörg Schrade & Hans-Peter Piepho & Eva Gallmann, 2020. "Influence of Increased Light Intensity on the Acceptance of a Solid Lying Area and a Slatted Elimination Area in Fattening Pigs," Agriculture, MDPI, vol. 10(3), pages 1-14, February.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yaqiong Zeng & Dingbiao Long & Bin Hu & Hao Wang & Shihua Pu & Yue Jian & Zuohua Liu & Shunlai Xu, 2023. "Study on Illumination Intensity and Duration of LED Light Sources for a Weaned Piglet House without Natural Light," Agriculture, MDPI, vol. 13(11), pages 1-11, November.
    2. Chengqi Liu & Han Zhou & Jing Cao & Xuchao Guo & Jie Su & Longhe Wang & Shuhan Lu & Lin Li, 2021. "Behavior Trajectory Tracking of Piglets Based on DLC-KPCA," Agriculture, MDPI, vol. 11(9), pages 1-22, September.
    3. Ma, Hongqiang & Xie, Yue & Min, Kai & Chen, Yufei & Liu, Yu & Wang, Shengxun & Ding, Ruixiang & Cai, Weihua, 2023. "Investigation on the control strategy of new spray cooling system based on PV/T and heat recovery in sow houses: As a case study in Nanchang, China," Renewable Energy, Elsevier, vol. 219(P1).
    4. S. Opderbeck & B. Keßler & W. Gordillio & H. Schrade & Hans-Peter Piepho & Eva Gallmann, 2020. "Influence of A Cooled, Solid Lying Area on the Pen Fouling and Lying Behavior of Fattening Pigs," Agriculture, MDPI, vol. 10(7), pages 1-19, July.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jagris:v:11:y:2021:i:4:p:324-:d:531332. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.