Mechanistic analysis of acid gas storage and oil recovery in naturally fractured reservoirs using single matrix block approach

The objective of this study is to assess the storage of acid gas, containing CO2 and H2S, in a depleted naturally fractured reservoir (NFR) using single matrix block (SMB) approach. The acid gas dissolution in oil is considered by Peng‐Robinson equation of state and compositional simulation. The PHREEQC package is used to determine acid gas solubility in formation brine. Three types of acid gases with different compositions are used for this study and their swelling behavior and miscibility in relation to the reservoir oil are analyzed. An SMB model, with a matrix block surrounded by fractures, is constructed, and validated for simulation of a real experiment. The simulation is conducted for synthetic and real reservoir fluids when the oil is in its residual saturation. A sensitivity analysis is performed to study the effects of key parameters, such as acid gas composition, reservoir pressure, permeability, porosity and matrix height on the storage capacity and oil recovery factor. The matrix has a volume of 27 m3 and about half of acid gas storage is achieved in the first 5 years while the simulations are run for 30 years. The results show that up to 90% of remained oil is recoverable, and more than 0.67 kmol of acid gas per cubic meter of matrix is stored whether matrix contains a real oil or a synthetic one. Higher storage is achieved for higher matrix porosities and heights and large H2S proportion in acid gas. In all cases about 10% of acid gas is trapped in water and the remaining 90% is dissolved in oil. The mineral trapping was more active in CO2‐rich acid gases. While about 10 kg of the matrix rock was dissolved in the acidic brine when the acid gas contained H2S, the amount of the dissolved minerals in acidic brine resulted from the injection of CO2‐rich acid gas was more than 16 kg. Finally, this study gives a comparative analysis of the storage performance of acid gas mixture and pure CO2. © 2024 Society of Chemical Industry and John Wiley & Sons, Ltd.