An optimized quad-ridged horn antenna with pyramidal sidewalls

The wideband gain and voltage standing wave ratio (VSWR) performance of quad-ridged horn antennas in general are restricted due to the excitation of higher order modes in the coaxial to quad-ridged waveguide transition. This results in large gain variations vs. frequency and break-up of the radiation patterns at higher frequencies. In this paper, a quad-ridged horn antenna is presented with optimized radiation characteristics and VSWR performance. The performance of the antenna was optimized by separating the antenna into two subsections, viz. a coaxial to quad-ridged waveguide transition section and a flared quad-ridged horn section. The performance of each section was optimized individually using a numerical solver – CST Microwave Studio. Three possible configuration of the coaxial to quad-ridged waveguide transition section were considered and optimized. Four configurations for the flared quad-ridged horn section were also investigated. The best performing configuration from each one of the two sections were combined to yield the final design of the optimized quad-ridged horn antenna. The numerical performance of the quad-ridged horn antenna was validated through measurements, performed in a compact antenna test range. The optimized antenna has a 12.5:1 frequency bandwidth from 0.8 to 10 GHz. Over this frequency range, the antenna has a VSWR performance typically better than 2.5:1, stable boresight gain and radiation patterns for both ports with more than 30 dB isolation between the two ports.