Numerical Investigation of Hydraulic Fracture Network Formation of Jointed Shale with Oriented Perforation

This paper aims at exploring the fracture evolution as well as capturing the fracture network formation of jointed shale during hydraulic fracturing process by numerical simulation using the Rock Failure Process Analysis System of Flow (RFPA—Flow). The simulations were successfully completed following two stages. In the first stage, a series of simulations are performed to investigate the influence of different angle-oriented perforations on fracture initiation and propagation. The simulation results agreed well with the experimental results confirming the validity of the RFPA-Flow code in the application. In the second stage, extensive hydraulic fracturing simulations on jointed shale with different angled-joint planes and different angle-oriented perforations were performed. The simulation results demonstrated that the fracture evolution changes significantly as the magnitude of α (the angle between perforation and the joint plane) increased. It was found that a large α value could lead to a larger the tensile stress region around the fracture tip resulting in more joint planes pulled apart. It could also induce more secondary fractures and hence a more complex fracture could be formed. As a result, the α value of 60° to 90° were found to aid in the fracture network generation. On the other hand, the angle β being the angle between the parallel joints and the maximum stress direction was another important factor in fracture evolution. Its influence on fracturing performance was similar to angle α. It was found that the initiation and breakdown pressure of jointed shale were in proportional to the magnitude of angle β. Therefore, this paper introduced an efficient approach to promote the formation of a complex fracture network in jointed shale with the presence of oriented perforation, which could offer valuable guidance for the design of unconventional reservoir reconstruction.