IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v14y2022i21p14029-d955768.html
   My bibliography  Save this article

Experimental Investigations of Flow Boiling Heat Transfer under Near-Critical Pressure for Selected Working Fluids

Author

Listed:
  • Dariusz Butrymowicz

    (Department of Thermal Engineering, Bialystok University of Technology, 15-351 Bialystok, Poland)

  • Kamil Śmierciew

    (Department of Thermal Engineering, Bialystok University of Technology, 15-351 Bialystok, Poland)

  • Jarosław Karwacki

    (The Szewalski Institute of Fluid-Flow Machinery of Polish Academy of Sciences, 80-231 Gdansk, Poland)

  • Aleksandra Borsukiewicz

    (Department of Energy Technologies, West Pomeranian University of Technology, 70-310 Szczecin, Poland)

  • Jerzy Gagan

    (Department of Thermal Engineering, Bialystok University of Technology, 15-351 Bialystok, Poland)

Abstract

This paper deals with experimental investigations of flow boiling in tubular ducts of selected refrigerants—R134a, R507A, and R600a—under near-critical pressures. Near-critical boiling is characterised by low specific enthalpy of evaporation. The positive effect of this feature is the fact that only a small amount of heat consumed by Organic Rankine Cycles is at a constant temperature. This allows a lower terminal temperature of the heating fluid and more effective utilisation of heat sources, especially of low-grade heat sources. The experimental investigations covered a heat flux density of 0.4 to 10 kW/m 2 and a mass velocity of 60 to 200 kg/(m 2 ·s). The results of the experimental data were compared to the modified heat transfer correlation of Gungor and Winterton, which provices the best fit for the obtained experimental data. The maximum heat transfer coefficient occurred at the two-phase quality—approximately 0.4 for all the tested fluids under high pressure conditions—which may be thought of as a characteristic feature of the boiling process under near-critical conditions. A modified Gungor–Winterton correlation improves prediction accuracy, especially under the lowest (up to 3 kW/m 2 ) and highest (over 7 kW/m 2 ) heat flux densities for all the tested fluids.

Suggested Citation

  • Dariusz Butrymowicz & Kamil Śmierciew & Jarosław Karwacki & Aleksandra Borsukiewicz & Jerzy Gagan, 2022. "Experimental Investigations of Flow Boiling Heat Transfer under Near-Critical Pressure for Selected Working Fluids," Sustainability, MDPI, vol. 14(21), pages 1-16, October.
    • Handle: RePEc:gam:jsusta:v:14:y:2022:i:21:p:14029-:d:955768
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/14/21/14029/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/14/21/14029/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Liu, Peng & Shu, Gequn & Tian, Hua & Wang, Xuan & Yu, Zhigang, 2018. "Alkanes based two-stage expansion with interheating Organic Rankine cycle for multi-waste heat recovery of truck diesel engine," Energy, Elsevier, vol. 147(C), pages 337-350.
    2. Shu, Gequn & Wang, Xuan & Tian, Hua & Liu, Peng & Jing, Dongzhan & Li, Xiaoya, 2017. "Scan of working fluids based on dynamic response characters for Organic Rankine Cycle using for engine waste heat recovery," Energy, Elsevier, vol. 133(C), pages 609-620.
    3. Pan, Lisheng & Wang, Huaixin & Shi, Weixiu, 2012. "Performance analysis in near-critical conditions of organic Rankine cycle," Energy, Elsevier, vol. 37(1), pages 281-286.
    4. Huang, Junwei & Xiao, Qingtai & Liu, Jingjing & Wang, Hua, 2019. "Modeling heat transfer properties in an ORC direct contact evaporator using RBF neural network combined with EMD," Energy, Elsevier, vol. 173(C), pages 306-316.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Jiménez-Arreola, Manuel & Pili, Roberto & Wieland, Christoph & Romagnoli, Alessandro, 2018. "Analysis and comparison of dynamic behavior of heat exchangers for direct evaporation in ORC waste heat recovery applications from fluctuating sources," Applied Energy, Elsevier, vol. 216(C), pages 724-740.
    2. Jiménez-Arreola, Manuel & Wieland, Christoph & Romagnoli, Alessandro, 2019. "Direct vs indirect evaporation in Organic Rankine Cycle (ORC) systems: A comparison of the dynamic behavior for waste heat recovery of engine exhaust," Applied Energy, Elsevier, vol. 242(C), pages 439-452.
    3. Ghasemi, Hadi & Paci, Marco & Tizzanini, Alessio & Mitsos, Alexander, 2013. "Modeling and optimization of a binary geothermal power plant," Energy, Elsevier, vol. 50(C), pages 412-428.
    4. Ghasemi, Hadi & Sheu, Elysia & Tizzanini, Alessio & Paci, Marco & Mitsos, Alexander, 2014. "Hybrid solar–geothermal power generation: Optimal retrofitting," Applied Energy, Elsevier, vol. 131(C), pages 158-170.
    5. Braimakis, Konstantinos & Karellas, Sotirios, 2017. "Integrated thermoeconomic optimization of standard and regenerative ORC for different heat source types and capacities," Energy, Elsevier, vol. 121(C), pages 570-598.
    6. Lecompte, S. & Huisseune, H. & van den Broek, M. & De Paepe, M., 2015. "Methodical thermodynamic analysis and regression models of organic Rankine cycle architectures for waste heat recovery," Energy, Elsevier, vol. 87(C), pages 60-76.
    7. Li, Jian & Ge, Zhong & Duan, Yuanyuan & Yang, Zhen & Liu, Qiang, 2018. "Parametric optimization and thermodynamic performance comparison of single-pressure and dual-pressure evaporation organic Rankine cycles," Applied Energy, Elsevier, vol. 217(C), pages 409-421.
    8. Ping, Xu & Yao, Baofeng & Zhang, Hongguang & Yang, Fubin, 2021. "Thermodynamic analysis and high-dimensional evolutionary many-objective optimization of dual loop organic Rankine cycle (DORC) for CNG engine waste heat recovery," Energy, Elsevier, vol. 236(C).
    9. Ping, Xu & Yang, Fubin & Zhang, Hongguang & Xing, Chengda & Pan, Yachao & Zhang, Wujie & Wang, Yan, 2023. "Nonlinear modeling and multi-scale influence characteristics analysis of organic Rankine cycle (ORC) system considering variable driving cycles," Energy, Elsevier, vol. 265(C).
    10. Fabio Fatigati & Diego Vittorini & Yaxiong Wang & Jian Song & Christos N. Markides & Roberto Cipollone, 2020. "Design and Operational Control Strategy for Optimum Off-Design Performance of an ORC Plant for Low-Grade Waste Heat Recovery," Energies, MDPI, vol. 13(21), pages 1-23, November.
    11. Ping, Xu & Yang, Fubin & Zhang, Hongguang & Xing, Chengda & Yao, Baofeng & Wang, Yan, 2022. "An outlier removal and feature dimensionality reduction framework with unsupervised learning and information theory intervention for organic Rankine cycle (ORC)," Energy, Elsevier, vol. 254(PB).
    12. Wang, Xuan & Shu, Gequn & Tian, Hua & Liu, Peng & Jing, Dongzhan & Li, Xiaoya, 2018. "The effects of design parameters on the dynamic behavior of organic ranking cycle for the engine waste heat recovery," Energy, Elsevier, vol. 147(C), pages 440-450.
    13. Shu, Gequn & Wang, Rui & Tian, Hua & Wang, Xuan & Li, Xiaoya & Cai, Jinwen & Xu, Zhiqiang, 2020. "Dynamic performance of the transcritical power cycle using CO2-based binary zeotropic mixtures for truck engine waste heat recovery," Energy, Elsevier, vol. 194(C).
    14. Li, Xiaoya & Xu, Bin & Tian, Hua & Shu, Gequn, 2021. "Towards a novel holistic design of organic Rankine cycle (ORC) systems operating under heat source fluctuations and intermittency," Renewable and Sustainable Energy Reviews, Elsevier, vol. 147(C).
    15. Michael Chukwuemeka Ekwonu & Mirae Kim & Binqi Chen & Muhammad Tauseef Nasir & Kyung Chun Kim, 2023. "Dynamic Simulation of Partial Load Operation of an Organic Rankine Cycle with Two Parallel Expanders," Energies, MDPI, vol. 16(1), pages 1-18, January.
    16. Hong Gao & Chao Liu & Chao He & Xiaoxiao Xu & Shuangying Wu & Yourong Li, 2012. "Performance Analysis and Working Fluid Selection of a Supercritical Organic Rankine Cycle for Low Grade Waste Heat Recovery," Energies, MDPI, vol. 5(9), pages 1-15, August.
    17. Baofeng Yao & Xu Ping & Hongguang Zhang, 2021. "Dynamic Response Characteristics Analysis and Energy, Exergy, and Economic (3E) Evaluation of Dual Loop Organic Rankine Cycle (DORC) for CNG Engine Waste Heat Recovery," Energies, MDPI, vol. 14(19), pages 1-32, September.
    18. Li, Xiaoya & Shu, Gequn & Tian, Hua & Shi, Lingfeng & Huang, Guangdai & Chen, Tianyu & Liu, Peng, 2017. "Preliminary tests on dynamic characteristics of a CO2 transcritical power cycle using an expansion valve in engine waste heat recovery," Energy, Elsevier, vol. 140(P1), pages 696-707.
    19. Xu, Weicong & Zhao, Li & Mao, Samuel S. & Deng, Shuai, 2020. "Towards novel low temperature thermodynamic cycle: A critical review originated from organic Rankine cycle," Applied Energy, Elsevier, vol. 270(C).
    20. Ma, Xiaofeng & Jiang, Peixue & Zhu, Yinhai, 2022. "Dynamic simulation model with virtual interfaces of supercritical working fluid heat exchanger based on moving boundary method," Energy, Elsevier, vol. 254(PB).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:14:y:2022:i:21:p:14029-:d:955768. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.