IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v12y2020i20p8706-d431944.html
   My bibliography  Save this article

Improving Mechanical Textile Recycling by Lubricant Pre-Treatment to Mitigate Length Loss of Fibers

Author

Listed:
  • Katarina Lindström

    (Department of Textile Technology, Faculty of Textiles, Engineering and Business, University of Borås, SE-501 90 Borås, Sweden)

  • Therese Sjöblom

    (Department of Textile Technology, Faculty of Textiles, Engineering and Business, University of Borås, SE-501 90 Borås, Sweden)

  • Anders Persson

    (Department of Textile Technology, Faculty of Textiles, Engineering and Business, University of Borås, SE-501 90 Borås, Sweden)

  • Nawar Kadi

    (Department of Textile Technology, Faculty of Textiles, Engineering and Business, University of Borås, SE-501 90 Borås, Sweden)

Abstract

Although there has been some research on how to use short fibers from mechanically recycled textiles, little is known about how to preserve the length of recycled fibers, and thus maintain their properties. The aim of this study is to investigate whether a pre-treatment with lubricant could mitigate fiber length reduction from tearing. This could facilitate the spinning of a 100% recycled yarn. Additionally, this study set out to develop a new test method to assess the effect of lubricant loading. Inter-fiber cohesion was measured in a tensile tester on carded fiber webs. We used polyethylene glycol (PEG) 4000 aqueous solution as a lubricant to treat fibers and woven fabrics of cotton, polyester (PES), and cotton/polyester. Measurements of fiber length and percentage of unopened material showed the harshness and efficiency of the tearing process. Treatment with PEG 4000 decreased inter-fiber cohesion, reduced fiber length loss, and facilitated a more efficient tearing process, especially for PES. The study showed that treating fabric with PEG enabled rotor spinning of 100% recycled fibers. The inter-fiber cohesion test method suggested appropriate lubricant loadings, which were shown to mitigate tearing harshness and facilitate fabric disintegration in recycling.

Suggested Citation

  • Katarina Lindström & Therese Sjöblom & Anders Persson & Nawar Kadi, 2020. "Improving Mechanical Textile Recycling by Lubricant Pre-Treatment to Mitigate Length Loss of Fibers," Sustainability, MDPI, vol. 12(20), pages 1-13, October.
    • Handle: RePEc:gam:jsusta:v:12:y:2020:i:20:p:8706-:d:431944
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/12/20/8706/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/12/20/8706/
    Download Restriction: no
    ---><---

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Paulien Harmsen & Michiel Scheffer & Harriette Bos, 2021. "Textiles for Circular Fashion: The Logic behind Recycling Options," Sustainability, MDPI, vol. 13(17), pages 1-17, August.
    2. Huantian Cao & Kelly Cobb & Michelle Yatvitskiy & Megan Wolfe & Hongqing Shen, 2022. "Textile and Product Development from End-of-Use Cotton Apparel: A Study to Reclaim Value from Waste," Sustainability, MDPI, vol. 14(14), pages 1-20, July.
    3. Isabella Bianco & Raffaella Gerboni & Giuseppe Picerno & Gian Andrea Blengini, 2022. "Life Cycle Assessment (LCA) of MWool ® Recycled Wool Fibers," Resources, MDPI, vol. 11(5), pages 1-16, April.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:12:y:2020:i:20:p:8706-:d:431944. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.