Quasi-Static and Dynamic Tensile Behavior of Water-Bearing Sandstone Subjected to Microwave Irradiation

Microwave irradiation on rocks before excavation is an effective method to reduce equipment wear and energy consumption during mechanical cutting. Rock mass excavation is usually carried out in a water-rich environment and exposed to dynamic loads, thus understanding the coupled effects of water content and loading rate on the mechanical behavior of rocks under microwave radiation is essential. In this study, sandstone samples with five levels of water content (from oven-dried to water-saturated) were exposed to microwave irradiation at a power of 700 W for 10 min. Brazilian disc tests were conducted on sandstone samples after microwave radiation under both quasi-static and dynamic loading conditions. Test results revealed that, with the increase of the initial water content, the microwave heating capacity of the rock is significantly improved. The surface temperature of the saturated samples is approximately 1.38 times higher than that of the dry ones. Moreover, weight, P-wave velocity, quasi-static and dynamic tensile strength of the rock decrease, while porosity and damage factor exhibit a similar growth law. Before microwave irradiation, the average value of the P-wave velocity and the quasi-static tensile strength of sandstone were about 2521.3 m·s −1 and 4.65 MPa. However, after microwave treatment, when the initial water content was 2%, 3%, 4% and 5.4%, the P-wave velocity decreased by 6.1%, 9.8%, 16.4% and 30.2%, while that quasi-static tensile strength reduced by 9.2%, 16.7%, 30.6% and 48.9%, respectively. For water-saturated samples under microwave irradiation, the porosity increases from 13.02% to 18.12% (showing an increase of 39.2%), and the damage value rises to 0.51. In addition, the dynamic tensile strength shows a significant loading rate dependence, and as the initial water content increases, also the dynamic increase factor (DIF) increases. At a given loading rate, the energy dissipation decreases with the increase of the initial water content, which indicates that the presence of water cause more significant damage to the rock when subjected to microwave radiation. Scanning electron microscopy (SEM) results indicate that the internal damage of the rock after microwave radiation is dominated by intergranular cracks, and crack density increases with increasing initial water content of the samples. The underlying damage mechanisms of microwave radiation on water-bearing sandstone were interpreted with the theory of pore water pressure and structural thermal stresses.