Improvement of Onsite Wastewater Systems Performance: Experimental and Numerical Investigation

Population growth and the associated increase in the use of Onsite Wastewater Treatment Systems (OWTS) in the Black Hills have been a reason for interest in nitrate contamination within the public water supply over the past few years. The main concern for the Black Hills is the presence of karst formation that all OWTS for wastewater travel faster, limiting the natural attenuation of wastewater contaminants. The treatment performance of common soils in the Black Hills and wood-based media was evaluated using soil column experiments and a numerical model, HYDRUS 2D. Nitrate treatment performances were evaluated using alluvial and cedar soils collected from the Black Hills, sand, woodchips (loose and dense), and biochar. This research investigated hydraulic and reaction parameters through a combination of experimental and inverse modeling approaches. A good agreement was obtained between the measured and model-predicted soil moisture content, with R 2 values ranging from 0.57 to 0.99. The model was calibrated using flow data and nitrate concentration data measured from leachate collected at the bottom of the experimental columns. Nitrate removal rates varied from 32.3% to 70%, with the highest removal rate in loose woodchips, followed by dense woodchip and biochar, and the lowest removal rate in alluvial materials. The biochar and loose woodchips removed an additional 20% compared to common soils, attributable to the enhanced denitrification rate due to higher water content and organic content. The use of woodchips and biochar should be implemented in OWTS, where there are known karst formations.