IDEAS home Printed from https://ideas.repec.org/a/gam/jagris/v13y2023i12p2234-d1293087.html
   My bibliography  Save this article

Comparison of Physiological, Anatomical, and Morphological Traits between Sugarcane Hybrids and Their Parents with Different Stalk Dry Weights in the Early Growth Stage under Hydroponic Conditions

Author

Listed:
  • Jidapa Khonghintaisong

    (Department of Agronomy, Faculty of Agriculture, Khon Kaen University, Khon Kaen 40002, Thailand)

  • Patcharin Songsri

    (Department of Agronomy, Faculty of Agriculture, Khon Kaen University, Khon Kaen 40002, Thailand
    Northeast Thailand Cane and Sugar Research Center, Faculty of Agriculture, Khon Kaen University, Khon Kaen 40002, Thailand)

  • Nakorn Jongrungklang

    (Department of Agronomy, Faculty of Agriculture, Khon Kaen University, Khon Kaen 40002, Thailand
    Northeast Thailand Cane and Sugar Research Center, Faculty of Agriculture, Khon Kaen University, Khon Kaen 40002, Thailand)

Abstract

The high stalk weight sugarcane cultivar has a special mechanism to obtain greater growth, which was inherited from its parents. Thus far, comparisons of the high stalk weight sugarcane cultivar growth with its parents and cultivars with a low stalk weight have never been reported. The purpose of this research was to reveal the growth mechanism of the high stalk dry weight cultivar KK3 by comparing its physiological, anatomical, and morphological traits to those of a low stalk dry weight cultivar (UT12) and their four parental cultivars under hydroponic conditions. Their growth characteristics were evaluated at 15-day intervals from 30 to 90 days after planting. The root traits were measured at 2 months after planting (MAP), whereas the anatomical and physiological parameters were collected at 3 MAP. Biomass was recorded at 1, 2, and 3 MAP. KK3 had similar anatomical root traits to its female parent, whereas it had similar aboveground morphological traits to its male parent. The comparison between UT12 and its parents revealed that almost all its root anatomical traits were similar to the female parent, but it did not differ in leaf anatomy and root system size. Some physiological traits of KK3 were not different from those of its parents. In contrast, the net photosynthesis rate (P N ), height, tiller number, stem dry weight, and stomatal density of UT12 were lower than those of its parent. For KK3, its small root stele and vessel size and high root length, surface area, and volume supported water uptake. The increase in stomatal density and decreased stomatal pore length may be appropriate characteristics for reducing water loss in this drought-resistant cultivar. Furthermore, KK3 exhibited a high water use efficiency (WUE) to promote biomass accumulation and growth despite its low transpiration and photosynthesis rates. This basic knowledge will be useful for selecting the parents based on their characteristics to create new sugarcane cultivars with a high stalk dry weight for drought stress during the early-growth-stage breeding programs and predicting their performance.

Suggested Citation

  • Jidapa Khonghintaisong & Patcharin Songsri & Nakorn Jongrungklang, 2023. "Comparison of Physiological, Anatomical, and Morphological Traits between Sugarcane Hybrids and Their Parents with Different Stalk Dry Weights in the Early Growth Stage under Hydroponic Conditions," Agriculture, MDPI, vol. 13(12), pages 1-20, December.
  • Handle: RePEc:gam:jagris:v:13:y:2023:i:12:p:2234-:d:1293087
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2077-0472/13/12/2234/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/2077-0472/13/12/2234/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zhang, Dongsheng & Li, Ali & Lam, Shu Kee & Li, Ping & Zong, Yuzheng & Gao, Zhiqiang & Hao, Xingyu, 2021. "Increased carbon uptake under elevated CO2 concentration enhances water-use efficiency of C4 broomcorn millet under drought," Agricultural Water Management, Elsevier, vol. 245(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.

      Corrections

      All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jagris:v:13:y:2023:i:12:p:2234-:d:1293087. See general information about how to correct material in RePEc.

      If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

      If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

      If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

      For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

      Please note that corrections may take a couple of weeks to filter through the various RePEc services.

      IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.