IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v226y2021ics0360544221006435.html
   My bibliography  Save this article

Experimental study on the spray steadiness of an internal-mixing twin-fluid atomizer

Author

Listed:
  • Li, Genbao
  • Li, Chuqiao

Abstract

Liquid breakup intensity in the near-nozzle region and droplet size fluctuations at different downstream positions of an internal-mixing twin-fluid (IMTF) atomizer were studied by using a high-speed camera and a Malvern Spraytec diffractometer, and the effect of operating conditions on spray steadiness was analyzed. The results show that under the operating conditions of this study, the primary breakup process of IMTF atomization is affected by various breakup modes, and the characteristic droplet diameters at a given position exhibit different degrees of fluctuation, which can be considered to be inherently unsteady. The primary breakup process at medium gas/liquid mass flow ratio (GLR) is more unsteady than that at either small GLR or large GLR. At different downstream positions, the steadiness of larger droplets is significantly lower than that of smaller droplets. Compared with the near-nozzle region, the spray steadiness is significantly improved in the fully developed region. Moreover, frequency spectrum analysis performed on the time-resolved data of various droplet characteristic diameters in the near-nozzle region shows the presence of a pulsation frequency in the spectrum diagrams. This pulsation frequency can be used for evaluating the influence of GLR on the spray steadiness.

Suggested Citation

  • Li, Genbao & Li, Chuqiao, 2021. "Experimental study on the spray steadiness of an internal-mixing twin-fluid atomizer," Energy, Elsevier, vol. 226(C).
    • Handle: RePEc:eee:energy:v:226:y:2021:i:c:s0360544221006435
    DOI: 10.1016/j.energy.2021.120394
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544221006435
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2021.120394?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Gvozdyakov, Dmitry & Zenkov, Andrey, 2021. "Improvement of atomization characteristics of coal-water slurries," Energy, Elsevier, vol. 230(C).
    2. Anastasia Islamova & Svetlana Kropotova & Pavel Strizhak, 2022. "Research into Energy Production from the Combustion of Waste-Derived Composite Fuels," Energies, MDPI, vol. 15(15), pages 1-4, August.
    3. Islamova, A.G. & Shlegel, N.E. & Strizhak, P.A., 2024. "Influence of collision conditions between aerosol flows of liquid droplets and solid particles typical for wet vortex dust collectors," Energy, Elsevier, vol. 298(C).
    4. Klimenko, A. Yu. & Kuznetsov, G.V. & Podgornaya, E.R. & Volkov, R.S. & Strizhak, P.A., 2024. "The composition of an atomized slurry fuel jet," Energy, Elsevier, vol. 288(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:226:y:2021:i:c:s0360544221006435. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.