IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v185y2019icp477-491.html
   My bibliography  Save this article

Evaluation of thermoelectric power generated through waste heat recovery from long ducts and different thermal system configurations

Author

Listed:
  • Elankovan, R.
  • Suresh, S.
  • Karthick, Krishnadass
  • Hussain, Mohammed Muaaz M.D.
  • Chandramohan, V.P.

Abstract

This paper presents the impact of Thermoelectric Generator (TEG) performance for recovering waste heat from long flue gas ducts with different thermal system configurations such as constant fluid temperature, counter flow, parallel flow and cold heat sink exposed to ambience. The counter flow configuration showed a good agreement with reference study for 2 m length of the duct at a high heat transfer coefficient of 100 W/m2K. The increase in duct length showed an adverse effect on TEG power generation due to the temperature drop of fluid along the duct rather than a constant temperature and hence the efficiency of TEG decreased in comparison with a constant fluid temperatures of flue gas and fresh air. Analyzing the performance of different thermal system configurations, results showed that cold heat sink exposed to ambient configuration has a potential to generate maximum TEG power output of 172.34 kW with an efficiency of 4.3% which are 40.22%, and 20.74% lower than the constant fluid temperature configuration respectively for 50 m duct length at a practical heat transfer coefficient of 25 W/m2K. The cold sink exposed to ambient configuration is economical whereas counter flow configuration is recommended for regenerative purposes after TEG power generation.

Suggested Citation

  • Elankovan, R. & Suresh, S. & Karthick, Krishnadass & Hussain, Mohammed Muaaz M.D. & Chandramohan, V.P., 2019. "Evaluation of thermoelectric power generated through waste heat recovery from long ducts and different thermal system configurations," Energy, Elsevier, vol. 185(C), pages 477-491.
  • Handle: RePEc:eee:energy:v:185:y:2019:i:c:p:477-491
    DOI: 10.1016/j.energy.2019.07.039
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544219313660
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.energy.2019.07.039?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Xiao, Heng & Qiu, Kuanrong & Gou, Xiaolong & Ou, Qiang, 2013. "A flameless catalytic combustion-based thermoelectric generator for powering electronic instruments on gas pipelines," Applied Energy, Elsevier, vol. 112(C), pages 1161-1165.
    2. Favarel, Camille & Bédécarrats, Jean-Pierre & Kousksou, Tarik & Champier, Daniel, 2014. "Numerical optimization of the occupancy rate of thermoelectric generators to produce the highest electrical power," Energy, Elsevier, vol. 68(C), pages 104-116.
    3. Karthick, Krishnadass & Suresh, S. & Singh, Harjit & Joy, Grashin C & Dhanuskodi, R., 2019. "Theoretical and experimental evaluation of thermal interface materials and other influencing parameters for thermoelectric generator system," Renewable Energy, Elsevier, vol. 134(C), pages 25-43.
    4. Lu, Hongliang & Wu, Ting & Bai, Shengqiang & Xu, Kangcong & Huang, Yingjie & Gao, Weimin & Yin, Xianglin & Chen, Lidong, 2013. "Experiment on thermal uniformity and pressure drop of exhaust heat exchanger for automotive thermoelectric generator," Energy, Elsevier, vol. 54(C), pages 372-377.
    5. Astrain, D. & Vián, J.G. & Martínez, A. & Rodríguez, A., 2010. "Study of the influence of heat exchangers' thermal resistances on a thermoelectric generation system," Energy, Elsevier, vol. 35(2), pages 602-610.
    6. Aranguren, P. & Astrain, D. & Rodríguez, A. & Martínez, A., 2015. "Experimental investigation of the applicability of a thermoelectric generator to recover waste heat from a combustion chamber," Applied Energy, Elsevier, vol. 152(C), pages 121-130.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Aljaghtham, Mutabe & Celik, Emrah, 2020. "Design optimization of oil pan thermoelectric generator to recover waste heat from internal combustion engines," Energy, Elsevier, vol. 200(C).
    2. Chen, Wei-Hsin & Chiou, Yi-Bin & Chein, Rei-Yu & Uan, Jun-Yen & Wang, Xiao-Dong, 2022. "Power generation of thermoelectric generator with plate fins for recovering low-temperature waste heat," Applied Energy, Elsevier, vol. 306(PA).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Fanciulli, C. & Abedi, H. & Merotto, L. & Dondè, R. & De Iuliis, S. & Passaretti, F., 2018. "Portable thermoelectric power generation based on catalytic combustor for low power electronic equipment," Applied Energy, Elsevier, vol. 215(C), pages 300-308.
    2. Elghool, Ali & Basrawi, Firdaus & Ibrahim, Thamir Khalil & Ibrahim, Hassan & Ishak, M. & Hazwan bin Yusof, Mohd & Bagaber, Salem Abdullah, 2020. "Multi-objective optimization to enhance the performance of thermo-electric generator combined with heat pipe-heat sink under forced convection," Energy, Elsevier, vol. 208(C).
    3. Zhu, Xingzhuang & Zuo, Zhengxing & Wang, Wei & Jia, Boru & Zhan, Tianzhuo, 2023. "Experimental research and optimization of a thermoelectric generator excited by pulsed combustion mode under limited heat dissipation for combined heat and power supply," Applied Energy, Elsevier, vol. 349(C).
    4. Merotto, L. & Fanciulli, C. & Dondè, R. & De Iuliis, S., 2016. "Study of a thermoelectric generator based on a catalytic premixed meso-scale combustor," Applied Energy, Elsevier, vol. 162(C), pages 346-353.
    5. Sourav Bhakta & Balaram Kundu, 2024. "A Review of Thermoelectric Generators in Automobile Waste Heat Recovery Systems for Improving Energy Utilization," Energies, MDPI, vol. 17(5), pages 1-49, February.
    6. Ma, Ting & Lu, Xing & Pandit, Jaideep & Ekkad, Srinath V. & Huxtable, Scott T. & Deshpande, Samruddhi & Wang, Qiu-wang, 2017. "Numerical study on thermoelectric–hydraulic performance of a thermoelectric power generator with a plate-fin heat exchanger with longitudinal vortex generators," Applied Energy, Elsevier, vol. 185(P2), pages 1343-1354.
    7. Björn Pfeiffelmann & Ali Cemal Benim & Franz Joos, 2021. "Water-Cooled Thermoelectric Generators for Improved Net Output Power: A Review," Energies, MDPI, vol. 14(24), pages 1-29, December.
    8. Ding, L.C. & Akbarzadeh, A. & Tan, L., 2018. "A review of power generation with thermoelectric system and its alternative with solar ponds," Renewable and Sustainable Energy Reviews, Elsevier, vol. 81(P1), pages 799-812.
    9. Yu, Shuhai & Du, Qing & Diao, Hai & Shu, Gequn & Jiao, Kui, 2015. "Start-up modes of thermoelectric generator based on vehicle exhaust waste heat recovery," Applied Energy, Elsevier, vol. 138(C), pages 276-290.
    10. Meng, Fankai & Chen, Lingen & Sun, Fengrui & Yang, Bo, 2014. "Thermoelectric power generation driven by blast furnace slag flushing water," Energy, Elsevier, vol. 66(C), pages 965-972.
    11. Song Lv & Zuoqin Qian & Dengyun Hu & Xiaoyuan Li & Wei He, 2020. "A Comprehensive Review of Strategies and Approaches for Enhancing the Performance of Thermoelectric Module," Energies, MDPI, vol. 13(12), pages 1-24, June.
    12. Mustafa, K.F. & Abdullah, S. & Abdullah, M.Z. & Sopian, K., 2017. "A review of combustion-driven thermoelectric (TE) and thermophotovoltaic (TPV) power systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 71(C), pages 572-584.
    13. Aranguren, P. & Astrain, D. & Rodríguez, A. & Martínez, A., 2015. "Experimental investigation of the applicability of a thermoelectric generator to recover waste heat from a combustion chamber," Applied Energy, Elsevier, vol. 152(C), pages 121-130.
    14. Shen, Rong & Gou, Xiaolong & Xu, Haoyu & Qiu, Kuanrong, 2017. "Dynamic performance analysis of a cascaded thermoelectric generator," Applied Energy, Elsevier, vol. 203(C), pages 808-815.
    15. Chen, Min & Gao, Xin, 2014. "Theoretical, experimental and numerical diagnose of critical power point of thermoelectric generators," Energy, Elsevier, vol. 78(C), pages 364-372.
    16. He, Ziqiang & You, Jingxiang & Kang, Dugang & Zou, Qunfeng & Zhang, Wenxiang & Zhang, Zhien, 2024. "Overall numerical simulation of chemical-thermal-electric conversion for an all-in-one thermoelectric generator based on micro scale combustion," Energy, Elsevier, vol. 292(C).
    17. Ding, L.C. & Akbarzadeh, A. & Date, Abhijit, 2016. "Electric power generation via plate type power generation unit from solar pond using thermoelectric cells," Applied Energy, Elsevier, vol. 183(C), pages 61-76.
    18. Gou, Xiaolong & Ping, Huifeng & Ou, Qiang & Xiao, Heng & Qing, Shaowei, 2015. "A novel thermoelectric generation system with thermal switch," Applied Energy, Elsevier, vol. 160(C), pages 843-852.
    19. Miao, Zhuang & Meng, Xiangning & Zhou, Sen & Zhu, Miaoyong, 2020. "Thermo-mechanical analysis on thermoelectric legs arrangement of thermoelectric modules," Renewable Energy, Elsevier, vol. 147(P1), pages 2272-2278.
    20. Massaguer Colomer, Albert & Massaguer, Eduard & Pujol, Toni & Comamala, Martí & Montoro, Lino & González, J.R., 2015. "Electrically tunable thermal conductivity in thermoelectric materials: Active and passive control," Applied Energy, Elsevier, vol. 154(C), pages 709-717.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:185:y:2019:i:c:p:477-491. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.