IDEAS home Printed from https://ideas.repec.org/a/caa/jnlrae/v60y2014ispecialissueid38-2013-rae.html
   My bibliography  Save this article

Machinability improvement using high-pressure cooling in turning

Author

Listed:
  • R. Drlička

    (Department of Quality and Engineering Technologies, Faculty of Engineering, Slovak University of Agriculture in Nitra, Nitra, Slovak Republic)

  • V. Kročko

    (Department of Quality and Engineering Technologies, Faculty of Engineering, Slovak University of Agriculture in Nitra, Nitra, Slovak Republic)

  • M. Matúš

    (Department of Quality and Engineering Technologies, Faculty of Engineering, Slovak University of Agriculture in Nitra, Nitra, Slovak Republic)

Abstract

Process fluids are used primarily for their cooling and lubricating effect in machining. Many ways to improve their performance have been proposed; the analysis of some of them is provided in the paper. The effect of high pressure cooling has been investigated with regard to chip formation and tool life. Standard and for high pressure application particularly designed indexable cutting inserts were used with fluid pressure 1.5 and 7.5 MPa. The pressure effect on tool life at different feed rates was observed as well. Not each cooling pressure value or machined material showed favourable chip formation. Tool life though has improved significantly while machining with a lower feed rate.

Suggested Citation

  • R. Drlička & V. Kročko & M. Matúš, 2014. "Machinability improvement using high-pressure cooling in turning," Research in Agricultural Engineering, Czech Academy of Agricultural Sciences, vol. 60(SpecialIs), pages 70-76.
  • Handle: RePEc:caa:jnlrae:v:60:y:2014:i:specialissue:id:38-2013-rae
    DOI: 10.17221/38/2013-RAE
    as

    Download full text from publisher

    File URL: http://rae.agriculturejournals.cz/doi/10.17221/38/2013-RAE.html
    Download Restriction: free of charge

    File URL: http://rae.agriculturejournals.cz/doi/10.17221/38/2013-RAE.pdf
    Download Restriction: free of charge

    File URL: https://libkey.io/10.17221/38/2013-RAE?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:caa:jnlrae:v:60:y:2014:i:specialissue:id:38-2013-rae. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    We have no bibliographic references for this item. You can help adding them by using this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Ivo Andrle (email available below). General contact details of provider: https://www.cazv.cz/en/home/ .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.